Publicidad
Idiomas disponibles
Idiomas disponibles
HAND PUMP OPERATION
Once you are secure and comfortable in your Saunders Lumbar Traction device,
you will apply traction by pumping air into the system using the hand pump
(see Figure 4 )
A) Close-up of gauge housing.
First, rotate the gauge housing of the hand pump to the "PUMP" position Begin
SLOWLY pumping air into the cylinder by stroking the pump handle all the way
out and all the way in Observe the gauge to make sure you are staying within
the guidelines provided by your health care provider When you have reached the
desired amount of stretch, rotate the gauge housing to the "HOLD" position Begin
timing your treatment now, following the instructions of your health care provider
CAUTION: Do not exceed the level of traction prescribed by your health care
provider The stretch provided by traction should never cause pain Relax...let your
traction device do the work
ENGLISH
B) Both in and out motions of the
pump fill the cylinder with air.
Figure 4. Hand pump operation
9 / 43
Publicidad
