GIA HTW-VP-20FJD Manual De Usuario página 19

PEDESTAL FAN HTW-VP-20FJD
REMOTE CONTROL
1. Turn on/off
• Connect the supplied power cable to the mains socket on the fan base and to the wall
socket.
• To turn the fan on or off, press "
NOTE: When using the remote control, point the remote control at the IR sensor on the fan base,
and make sure there is no obstacle between the remote control and the IR sensor.
2. Set speed
• When the fan is on, press "
select the desired speed level (totally 12 speed levels + strong wind). The corresponding
speed level indicator is displayed on the control panel .When the wind speed reaches 12,
press "
display.
• Also when the fan is on, press "
wind, and shows "HI" on the display.
3. Set oscillation
• When the fan is on, press "
or deactivate left and right oscillation.
• When the fan is on, press "
deactivate up and down oscillation.
• When you press "
oscillation state, in the mean time indicator on the display screen turns off. Press "
button one more time can recover the oscillation.
" on the control panel (or on the remote control "
" on the control panel (or on the remote control "
" on the control panel again to set the strong wind mode, and shows "HI" on the
" on the control panel (or on the remote control) to activate
" on the control panel (or on the remote control) to activate or
" on the remote control, it will be stop and memory the before one
"on the remote control to operate the highest speed
USER MANUAL
USE
").
") to
"
19
