GIA HTW-VP-20FJD Manual De Usuario página 20

USER MANUAL
USE
4. Set operating modes
Mode button "
switch from "Normal mode
cycle in this order.
The corresponding icon illuminates on the control panel .
• Normal mode: The fan runs at the set speed. This mode without icon illuminated.
• Natura mode (
initially set fan speed, so that natural and pleasant air circulation can be generated.
• Sleep mode (
changes to a next lower level every 30 minutes, the wind speed can be down to 1 setting
at the lowest.
• ECO mode (
ding to the sensed ambient temperature, and at the same time, the icon on the display will
be illuminated, and the display on the machine will show the value of the sensed ambient
temperature in real time.
5. Set mood Lamp brightness
Press " " on the control panel or remote control to toggle the lamp on/off and adjust the bri-
ghtness of the mood lamp.
6. Set switch-on/off timer
Timer switch-on time can be set in standby mode and timer switch-off time can be set in wor-
king mode. Press "
hours can be set.
7. Replacement of remote control battery
The remote control is powered by a CR2025 button cell. Replace the battery when the battery depletes.
• Find the battery compartment door on the back of the remote control. Press and hold the
tab (A) and simultaneously pull the battery tray out (as shown in the figure below), and
place a new CR2025 battery in the battery tray with correct polarity indicated, then close
the battery tray.
1
20

" (only on the remote control). After pressing this button mode, the fan will
Natural mode
): The fan automatically changes the speed at intervals according to the
): The fan runs at the set speed initially, then the speed automatically
):In this mode, the machine automatically adjusts the wind speed accor-
" on the control panel (or on the remote control) to set a timer (up to 12
2
A
PEDESTAL FAN
Sleep mode Eco mode
HTW-VP-20FJD
Normal mode"