MERCK Millex-VV Filter SLVV033RS Manual Del Usuario página 5

Specifications and
Performance Characteristics
Materials
Hydrophilic Durapore
Membrane
polyvinylidene fluoride (PVDF)
Millex
Pore size Millex
Millex
Modified acrylic copolymer
Housing
(MMA)
Dimensions
Inlet to outlet 27 mm (1 .06 in .)
Diameter 33 mm (1 .30 in .)
Filtration area 4 .52 cm
Temperature
45 °C (113 °F)
limit
Pressure limit 10 .3 bar (150 psi) inlet
at 21 °C maximum
Filtration volume 10 mL to 100 mL
Hold-up volume ≤ 0.1 mL after air purge
Sterilization
Gamma irradiation
method
Female Luer-Lok™ inlet; male
Connections
Luer-slip outlet
Flow rate at
Millex
2.1 bar (30 psi), Millex
21 °C Millex
®
-VV filter: 0 .10 µm
®
-GV filter: 0 .22 µm
®
-HV filter: 0 .45 µm
®
(0 .70 in )
2 2
-VV filter: ≥ 25 mL/min
®
-GV filter: ≥ 40 mL/min
®
-HV filter: ≥ 300 mL/min
®
Notice
We provide information and advice to our customers
on application technologies and regulatory matters
to the best of our knowledge and ability, but without
obligation or liability . Existing laws and regulations are
to be observed in all cases by our customers . This also
applies in respect to any rights of third parties . Our
information and advice do not relieve our customers of
their own responsibility for checking the suitability of
our products for the envisaged purpose .
Contact Information
For the location of the office nearest you, go to
SigmaAldrich .com/offices .
Disposal
Follow precautions for disposal of items contaminated
with potentially infectious or hazardous biological
material according to all applicable international,
federal, state, and local regulations .
Technical Assistance
Visit the tech service page on our web site at
SigmaAldrich .com/techservice .
Any serious incident of this device should be reported
to manufacturer and competent authority of country
where user is established .
Standard Warranty
The applicable warranty for the products listed in this
publication may be found at SigmaAldrich .com/terms .
5 of 58