brondell EasySpa LES-12 Manual Del Usuario página 7

PRODUCT INSTALLATION
Installing the bidet attachment
1. Remove the existing toilet seat.
a. Lift hinge covers and use flathead
or Phillips head screwdriver to
remove the mounting bolts.
Alternatively, you may need
to loosen mounting bolts
underneath the seat.
b. Remove the toilet seat and set
the seat, mounting bolts, and
hardware aside.
Step 1b
2. Turn off water supply valve and
flush toilet.
a. Turn off water supply at the wall
to stop flow of water.
b. Flush toilet and hold down
handle to completely empty toilet
tank.
c. Disconnect water supply hose
from the fill valve under the toilet
tank.
Step 2c
3. Connect ⅞" T-Valve to water supply
line and fill valve under toilet tank.
a. Install the ⅞" T-Valve with
included rubber washer to the
incoming water connection on
the bottom of your toilet tank.
Ensure the rubber washer is
properly seated, tapered side up.
Step 3a
b. Connect the cold water supply
line coming from the wall to the
bottom of the T-Valve.
Step 3b
4. Connect the bidet hose to the
T-Valve.
a. The ends of the bidet hose are
two different sizes. Determine
which is the smaller of the two
ends.
7