Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
_-] CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power
cord
assemblg, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 24 volt-60Hz electric
power. The included transformer
changes
standard
120-volt AC house power to 24 volts.
Plug the transformer
into a 120-volt
outlet
onlg.
Be sure the outlet is alwags live so it can not be
switched off bg mistake.
• Replace the top cover.
• Replace the salt hole cover.
PROGRAMMING THE CONTROL
CONTROL SETTINGS REgUIRED upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORMER IS PLUGGED INTO THE
ELECTRICAL OUTLET, 12:00 PM (flashing), and an
arrow I_ is displaLled next to PRESENT TIME on
the faceplate
decal. The blue indicator
light will
also flash. Program the control as instructed
below.
I-
t
If .-no---
is flashing,
use the UP •
button
to set the correct F code as follows: F18 for
GXSF18G. If Llou pass bLI the correct code number,
use the DOWN •
button. Then press the NODE
button to accept the correct model.
• A "beep" sounds while pressing buttons for control
programming.
One beep signals a change in the
control displaLI. Repeated beeps mean the control
will not accept a change from the button Llou have
pressed, and Llou should select another
button.
• To program
the control, Llou will use the UP •,
DOWN •
and MODE buttons.
• Use the MODE button to scroll arrow
!_ to desired
control function.
10
SET PRESENT TIME OF DAY
1. Press the MODE button
_L
2: In
until arrow I_ points to
p,
__
ILl i_ PRESENTTJME
L
PRESENT TIME.
2. Press UP •
or DOWN
•
button to set. The UP button advances the
time; the DOWN button moves the time in reverse.
If the present time is between
noon and midnight,
be sure PM shows in the displaLI. If the present time
is between
midnight and noon, be sure AM shows
in the displaLI.
NOTE: Each press of an UP •
or DOWN •
button
changes the time bLI one minute. Holding the button
changes the time at a rapid rate.
3. When the present time is correct, press MODE
to
accept.
SET WATER HARDNESS NUMBER
1. Press the MODE button
&'v_
2Ei_
until arrow I_ points to
- -_
.j
HARDNESS.
.ARDNESS
2. Press UP •
or DOWN •
button to set Llour water hardness number
in the
displaLI. DOWN decreases the hardness value. UP
increases the hardness value.
NOTE: Each press of a button changes the displaLI
bLI 1, between
1 and 25. Above 25, the displaLI
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.
Publicidad
