MESTIC MKK-400 Instrucciones De Uso página 8

27. Use the handle when moving the heater.
28. The grille does not provide full protection for young children and people with mental disabilities.
29. The grille on this heater is designed to prevent direct access to heating elements and must be in place when the
heater is in use.
30. The heater must not be used if the ceramic panels are damaged.
31. Do not use this heater in small rooms where there are persons unable to leave the room on their own, unless they
are under constant supervision.
32. Do not cover the air inlet or outlet or place objects close to the unit that could obstruct air flow.
33. To prevent battery leakage: remove the battery from the remote control when it is empty or before storing it for an
extended period of time.
34. If the heater is not used for an extended period, unplug it.
First use
When switched on for the first time, the appliance may produce a slight odour. Ensure adequate ventilation.
How to use
1. Connect the power cord to the socket and check that the mains voltage matches what is indicated on the appliance
rating plate before connecting it to an earthed socket.
2. The heater can be operated using the front manual controls or the remote control.
3. The on/off button switches the heater on or off.
4. Tem. button:
Press repeatedly to increase the desired room temperature. After pressing the temperature button, the set
temperature flashes on the display for 3 seconds before the appliance displays the room temperature again. When
the desired temperature is reached, the unit switches to fan mode.
5. Timer button:
Press repeatedly to extend the running time at 1-hour intervals. The timer can be set from 1-12 hours. The display
shows the current set running time. When the display shows the timer duration, the h symbol is lit next to the timer.
To cancel the timer, press the timer button repeatedly until 00 is displayed.
6. Swing button:
Press to turn the oscillation function on and off. When in operation, the heater is rotated horizontally back and forth
and the oscillation indicator O will light up.
7. Mode/On/Off button:
Press this button to select the power setting:
• Fan: fan
• Low: low heat setting
• High: high heat setting
• Shutdown: switch off
If you press this button to switch off the appliance, the fan indicator light will blink, the power indicator light will
switch off and the appliance will switch off after about 30 seconds.
Battery replacement
The remote control is powered by a lithium button cell battery (CR2025). Should the remote control stop responding,
replace the battery according to the instructions below:
1. On the back of the remote control: press tab A to the right.
2. Slide out the battery drawer B.
3. Replace the battery with the same type and make sure the positive side is facing up.