EHEIM incpiria marine 230 Manual De Instrucciones página 18

English
3. Install the larger elbow ⑭ and place the emergency overflow into the collection chamber ⑮ of the
filter basin.
Installing the aquarium lighting (only incpiria marine) (⌦E)
1. Install the EHEIM powerLED+ ⑰ lighting in accordance with the corresponding operating manual.
‧ Make sure that the EHEIM powerLED+ lighting is securely positioned in the profile ⑯ on the front
sides of the aquarium.
‧ The aquarium lighting included in the scope of delivery is only intended for fluorescence and
coral-zooxanthellae symbioses.
6. Commissioning
Filling the aquarium
CAUTION! Material damage.
▶ Do not use hard objects or cleaning agents for cleaning.
1. Before filling, thoroughly clean the aquarium with warm water and a soft, clean sponge.
2. Decorate the aquarium with gravel, stones, plants, etc.
CAUTION! Material damage.
▶ When filling the aquarium, please always pay attention to the water level in the filter basin.
The aquarium is equipped with the "silent outflow shaft" that EHEIM has developed. The water level in
the aquarium is constructively determined and is always at least 15 mm below the LED lights.
3. Slowly fill the aquarium with water. When the aquarium has been filled with enough water, the water
begins to flow into the filter basin through the inflow pipe.
4. Continue filling the aquarium with water until the pump in the filter basin is completely covered
(approx. 18 cm).
Switching on the accessories
DANGER! Personal injury or material damage.
▶ Heed the operating manuals for the accessories, especially the chapters on safety, commissioning
and operation!
1. Switch on the accessories in the aquarium in accordance with the associated operating manuals.
Switching on the cabinet lighting
1. Switch on the EHEIM incpiraATMOS RGB cabinet lighting in accordance with the relevant operating
manual.
Adjusting the water level height
The water level must be adjusted once after the aquarium has been filled. Bothersome running noises are
avoided through water backlogging. To do so, proceed as follows:
18