Simplicity SLC92 Manual Del Propietário página 82

INSPECTION OF THE OIL LEVEL IN THE ENGINE
Park the riding mower on a horizontal surface. Open the hood and unscrew the cap of the filling opening. Screw out the oil dipstick,
wipe it dry, reinsert it and screw in. Then again screw it out and take the oil level reading.
The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so that it reaches the "FULL" mark.
Further details about checking and filling of oil are included in a separate user's manual supplied by the
engine's manufacturer.
INSPECTION OF CABLES AND BOLT CONNECTIONS
Visually inspect the condition of cables and manually check the tightness of bolt connections.
INSPECTION OF WORKING ORDER OF BRAKES
Check that the brakes work properly. Proceed as follows:

Park the machine on an even surface and turn off the engine.

Step on the brake pedal and engage the parking brake.

Using the by-pass lever disengage the rear wheel drive.

Try to push the machine forward. If the rear wheels rotate, then the brakes need to be serviced. Contact an authorised service
centre to have them adjusted.
INSPECTION OF THE WORKING ORDER OF SAFETY ELEMENTS
Before every use of the riding mower, check the working order of safety elements:

switch under the seat

"R" switch for deactivation of the mowing deck disengagement for reversing
6.2.2 AFTER FINISHING WORK
CONFIGURING THE MOWER
After finishing mowing, elevate the mowing deck to the highest position and disable the drive for the mowing blades.
Turn off the ignition, step on the brake pedal and secure the mower in position with the parking brake.
CLEANING THE MOWER
Remove all dirt and grass remains from the surface of the tractor, the ejection chute and the mowing deck.
Thoroughly clean the textile sack of the grass catcher. When it is clogged with grass, the ability of the mower to fill the grass catcher
is reduced.
WASHING THE MOWER
Before washing it, park the mower on a suitable even surface.

Grass catcher:
- remove the grass catcher from the machine, wash it and allow it to dry naturally.

Plastic parts on the machine:
- clean using a sponge and soapy water

Mowing deck:
- wash the inside including the part of the ejection chute
- slide a hose of a suitable diameter on to the fittings on the mowing deck cover. Start the engine, engage the mowing
deck and flush out the mowing deck with a current of water for 10 minutes.
6.2.2
This flushing procedure needs to be performed at the end of every mowing session.
Avoid washing with water in the vicinity of electrical accessories on the control panel, battery, etc.
82