Filling With Water; Attaching Accessories - Beem Comfort de Luxe Manual De Instrucciones

Comfort de Luxe

Filling with water

Loosen and remove the
‹
multaneously press and unscrew the
tank cap.
Fill the tank with water. Use the meas-
‹
uring cup (18) and filling funnel (19).
The maximum filling quantity is 1.0
litre.
Screw on the tank cap again.
‹
Simultaneously press the tank cap
‹
and screw it tight.
NOTE
► Also pay attention to the section
Refilling with water (page 33).
Connecting the steam hose
Push down the cover of the connect-
‹
ing socket (8).
Insert the connector of the steam
‹
hose into the connecting socket and
allow it to snap in.
Opening/closing the accessories
compartment
To open the accessories compartment
‹
(10), press the release button (11) and
lift off the upper part of the appliance.
To close the accessory compartment,
‹
insert the accessory parts properly
and put the recess on the front of the
upper part of the appliance onto its
counterpart in the accessory compart-
ment. Press down the back of the up-
per part of the appliance until it snaps
in.
30
tank cap. Si-
‹
NOTE
►
‹
‹
NOTE
►
‹
‹

Attaching accessories

Take the required accessory out of the
accessory compartment (10).
Allow accessories used to complete-
ly cool down after use and return
them to the accessory compartment.
Connecting/removing
extension tubes
Push the extension tubes (13) onto
the steam spray gun (29) until they
snap in.
To remove the extension tubes (13),
press the release button (28) and pull
off the extension tubes.
Depending on requirements, you
can use up to three extension tubes.
Attaching the floor brush
Push the connector (14) onto the
floor brush so that the connection
faces downwards, then turn the con-
nector upwards 180° in a clockwise
direction (image A1).
Push the connector onto the exten-
sion tube or steam spray gun (29)
until it engages.
BEEM - Elements of Lifestyle
EN