Descargar Imprimir esta página

Bosch NGM8059UC Instrucciones De Instalación página 10

Placas a gas

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us Installation procedure
Apply the included foam sealing tape around the edges
2.
of the underside of the appliance along the rough-in box
flange.
Attach the hold-down brackets to the underside of the
3.
cooktop with the provided short screws and washers.
Loosely tighten the screws so the clamps do not move
freely. Rotate the hold-down brackets so that the
appliance can be placed in the cutout.
Note: The rating plate will not be accessible after
installation. Make a note of your appliance's details or
refer to the enclosed appliance certificate.
→  "Rating plate location", Page 18
4.2 Installing the pressure regulator
WARNING
Do not attempt any adjustment of the pressure regulator,
except when converting to propane. Adjustments could
lead to leaks or cause incorrect gas pressure to the
appliance.
Make sure the used gas connection line is not connected
to the gas supply, before carrying out the following steps.
Note: All pipe connections must be sealed in accordance
with local codes.
10
Identify the parts of the pressure regulator.
1.
a
Appliance manifold connection
b
Conversion cap
c
Pressure regulator
d
Arrow on pressure regulator, shows the
direction of gas flow
Apply Teflon® tape on the threads of the manifold pipe.
2.
Install the pressure regulator (supplied with cooktop) to
the gas inlet with the gas flow arrow facing the manifold
inlet.
Firmly hand tighten the regulator, then further tighten ¼
3.
turn to a maximum of one complete turn. Align the
regulator so that the conversion cap is easily
accessible.
4.
WARNING Never reuse a gas connector.
Repeated bending, flexing, or extreme vibration will
cause metal fatigue and must be avoided.
Apply Teflon® tape to the male threads, then connect a
new ½" metal flex line or fixed metal pipe connection to
the pressure regulator.
Note: For installations with little space, use a 90° street
elbow (not supplied) to orient the regulator horizontally.
4.3 Securing the cooktop to the countertop
The cooktop must be secured from below using the hold-
down brackets provided.
WARNING
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.

Publicidad

loading

Este manual también es adecuado para:

Ngm8659uc