Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Requirement: Complete the installation instructions in this
manual up to and including section
→ "Securing the cooktop to the countertop", Page 10
before starting the LP conversion.
Locate the pressure regulator on the bottom right end of
1.
the appliance.
Remove the hexagon shaped conversion cap from the
2.
regulator. Make sure not to dislodge the gasket
the cap or the spring
inside the regulator.
Grasp the plastic orifice stem
3.
forcefully from the conversion cap
snugly into an indent in the cap and may require a
strong pull to remove. It may be helpful to gently "rock"
the plastic stem while pulling it from the metal cap.
Rotate the stem 180°
4.
a Confirm that the button end of the orifice stem is away
from the conversion cap.
a Confirm that the letters "LP" on the orifice stem are
upside down when the conversion cap is set flat on its
head.
Snap the orifice stem back in place in this position
5.
inserting it into the indent in the conversion cap
Insert the hexagon cap back into the regulator and
on
6.
tighten, do not over-tighten.
IMPORTANT: Attach the metallic sticker included with
7.
the LP conversion kit to the bottom of the appliance as
shown. This sticker provides notice that the appliance
has been converted for use with LP gas. It should be
located near the appliance rating plate.
→ "Rating plate location", Page 18
Note: If you change the type of gas back to natural gas
at a later point, remove the sticker.
Conversion to LP gas en-us
firmly and pull it
. The stem snaps
.
.
15
Publicidad
