Craftsman WEEDWACKER 316.73193 Serie Manual Del Operador página 8

5. Insert a nut into one of the hexagonal recesses in the back of the
rear handle bracket (Fig. 5). Make sure the round side of the nut
faces outward. Hold the nut in place with a finger. Insert a bolt
into the corresponding hole in the front handle bracket (Fig. 5).
Tighten the bolt with a flat-head or T20 Torx® screwdriver.
Repeat this step until all four (4) bolts are securely installed.
6. Push the latch pin completely into the small hook on the handle
(Fig. 6). Lift the latch lever up and push it toward the large hook
(Fig. 6). Push the latch loop over the large hook (Fig. 6).
7. Hold the unit in the operating position (Fig. 19). Move the handle
up or down the shaft housing to a comfortable location (Fig. 7).
Make sure the handle is positioned beyond the end of the safety
label (Fig. 7).
8. Tilt the handle to the desired position.
9. Flip the latch lever down to secure the handle.
Adjusting the Handle
If the handle requires adjustment:
1. Flip the latch lever up to loosen the handle (Fig. 7).
2. Hold the unit in the operating position (Fig. 19). Move the handle
up or down the shaft housing to a comfortable location (Fig. 7).
Make sure the handle is positioned beyond the end of the safety
label (Fig. 7).
3. Tilt the handle to the desired position.
4. Flip the latch lever down to secure the handle.
Nut (x4)
Bolt (x4)
Small
Hook
Large
Hook
Handle
Shaft
Housing
8
Fig. 5
Latch Loop
Latch
Lever
Latch Pin
Fig. 6
Safety Label
Latch Lever
Fig. 7