GE GXSF40H Manual Del Propietario E Instrucciones De Instalación página 10

Installation Instructions
_-] CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assemblg, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 2/4 volt-60Hz electric
power. The included transformer changes
standard 120-volt AC house power to 24 volts.
Plug the transformer into a 120-volt outlet onlg.
Be sure the outlet is alwags live so it can not be
switched off bg mistake.
• Replace the top cover.
• Replace the salt hole cover.
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
® O
CONTROL SETTINGS REQUIRED upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORMER IS PLUGGED INTO THE
ELECTRICAL OUTLET, 12:00 PM (flashing), and an
arrow I_ is displaLled next to PRESENT TIME on
the faceplate decal. The blue indicator light will
also flash. Program the control as instructed
below.
If [orl--- is flashing, use the UP • button
to set the correct F or H code as follows: F40 for
GXSF40H. If Llou_pass by the correct code number,
use the DOWN I' button. Then press the MODE
button to accept the correct model.
• A "beep" sounds while pressing buttons for control
programming. One beep signals a change in the
control display. Repeated beeps mean the control
will not accept a change from the button you have
pressed, and Llou should select another button.
• To program the control, gou will use the UP •,
DOWN • and MODE buttons.
• Use the MODE button to scroll arrow I_ to desired
control function.
10
SET PRESENT TIME OF DAY
1. PresstheMODEbutton _ 2:IN t
until arrow I_ points to P,
--
PRESFNTTmMI =
PRESENT TIME.
2. Press UP • or DOWN
• button to set. The UP button advances the
time; the DOWN button moves the time in reverse.
If the present time is between noon and midnight,
be sure PM shows in the displaLI. If the present time
is between midnight and noon, be sure AM shows
in the displaLI.
NOTE: Each press of an UP • or DOWN • button
changes the time bLI one minute. Holding the button
changes the time at a rapid rate.
3. When the present time is correct, press MODE to
accept.
SET WATER HARDNESS NUMBER
1. Press the MODE button [t_
25
]
until arrow I_ points to
[
/
HARDNESS. _j HARDNESS
J
2. Press UP • or DOWN •
button to set Llour water hardness number in the
displuLI. DOWN decreases the hardness value. UP
increases the hardness value.
NOTE: Each press of a button changes the displaLI
bLI 1, between 1 and 25. Above 25, the displaLI
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.