Descargar Imprimir esta página

Lockncharge ECO Safe Charge Manual De Instrucciones página 5

Unidad de gestión de alimentación
Ocultar thumbs Ver también para ECO Safe Charge:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
Using the Power Distribution Unit Without the Remote Control
Setting the operating mode without the Remote Control:
1.
Pressing the MODE button consecutively will cycle the Power Distribution Unit through its different operating modes in this
sequence: SAFE-ON to ECO-TIMER-ALL to ECO-TIMER-CYCLE to SAFE-OFF and repeating from the start.
2.
The MODE indicators will indicate the operating mode of Power Distribution Unit:
a. In SAFE-ON mode, the SAFE ON indicator will illuminate continuously.
b. In ECO-TIMER-ALL mode, the TIMER ALL indicator will flash the number of times corresponding to the programmed timer
duration. Eg Three flashes indicates a 3-hour setting.
c. In ECO-TIMER-CYCLE mode, the CYCLE ALL indicator will flash the number of times corresponding to the Programmed timer
duration. Eg One flash indicates a 1-hour setting.
NOTE: The outlet indicator will show the outlet that is ON;
• If the outlet is powered OFF the outlet indicator will be OFF.
• If the outlet is powered ON, the outlet indicator will be ON.
d. In SAFE-OFF mode, all three MODE indicators will be OFF.
Setting the Programmed Timer Duration in ECO-TIMER-ALL or ECO-TIMER-CYCLES Modes
1.
When the Power Distribution Unit is in ECO-TIMER-ALL mode, pressing and holding the MODE
button on the Power Distribution Unit for 3-seconds will allow the programmed timer duration
to be changed.
2.
After 3-seconds have elapsed the TIMER ALL indicator will flash quickly.
3.
Continuing to hold the MODE button down will cycle the programmed timer duration through
this sequence, pausing for 3-seconds between each duration option;
• 1-hour (#1 outlet indicator will illuminate),
• 2-hours (#2 outlet indicator will illuminate),
• 3-hours (#3 outlet indicator will illuminate),
• 4-hours (#4 outlet indicator will illuminate), and repeat from the start.
4.
Release the MODE button on the desired Time setting; e.g. if you want the ECO-TIMER-ALL to
charge for 2 hours, release the MODE button when #2 outlet indicator is illuminated.
5.
The TIMER ALL indicator will flash the number of times corresponding to the number of hours
programmed; e.g. Two Flashes indicate a two hour setting.
6.
The programmed timer duration will survive any loss of power.
Safety Instructions
For your safety - Discard the Power Distribution Unit if the enclosure is damaged.
To reduce the risk of fire, electrical shock and/or injury, the following basic precautions should be followed:
This device is not intended for use by persons (including children) with reduced physical, sensory and mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instructions concerning the use of the device by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with this device.
For indoor use only. Keep away from all sources of water or moisture. Never expose the devices to the rain or dangerous gas.
Do not overload.
Before using this device, check and make sure the electrical appliances are correctly and properly connected and installed
according to the requirements of those appliances.
Do not operate any appliance with damaged cord or plug.
Do not try to repair, disassemble or modify this device. There are no user-serviceable parts inside.
Do not use this device other than for its intended use.
Arrange the power cord away from traffic areas where it will not be tripped over.
This device may be warm during working. Keep it in a dry and cool place and do not cover.
Although the outlets are OFF, this device is powered when the main supply is connected and switched on.
FF
te
nit
e

Publicidad

loading

Productos relacionados para Lockncharge ECO Safe Charge