Publicidad
Idiomas disponibles
Idiomas disponibles
10.3
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
NOTE
We recommend to use the non-pollutant type oil.
11
STORE THE MACHINE
NOTE
Clean the machine before storage.
1. Remove the battery pack.
2. Attach the scabbard (optional).
3. Cool the motor.
4. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
5. Remove keys or tools used for maintenance.
6. Store the machine:
•
indoors and out of children.
•
prevent from inclement weather.
12
TROUBLESHOOTING
Problem
Possible cause
The battery pack is
not installed tight-
The motor does
ly.
not start when you
pull the trigger.
The battery pack is
out of power.
The machine
The machine has
smokes during op-
damage.
eration.
English
Problem
The motor is on,
blades do not
move.
There is too much
noise and/or vibra-
tion during opera-
tion.
13
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Charger model
14
Solution
Make sure that
you tighlty install
the battery pack in
the machine.
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, 2 year commercial power
Charge the battery
train warranty, 2 year commercial battery warranty against
pack.
defects in materials, parts or workmanship. Greenworks, at its
1. Immediately
own discretion will repair or replace any and all parts found
stop the ma-
to be defective, through normal use, free of charge to the
chine.
customer. This warranty is valid only for units which have
been used for personal or commercial use and that have been
2. Remove the
maintained in accordance with the instructions in the owners'
battery pack.
manual supplied with the product from new.
3. Speak to serv-
ice center.
9
Possible cause
The machine has
damage.
The blades are
blocked.
The parts are loos-
en.
The parts have
damage.
TECHNICAL DATA
82 V
2800/3200/3600/4000
(±10%) SPM
26''
1.2''
8.4lbs
GL500 and other GL/GLW
series
GC420 and other GC series
LIMITED WARRANTY
EN
Solution
Do not use the ma-
chine and speak to
service center.
Remove battery
pack then clear
blockage from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
chine and speak to
service center.
Publicidad
