Parameter Setting (Setup) From Panel - ITALFARAD PFC144evo Manual De Uso

To access the programming menu (setup) :
 To enter parameter programming the unit must be in TEST mode (first programming)
Indication
of TEST
mode
Firmware
revision
E
N
or in MAN mode.
MAN
mode
icon
Tot kvar
inserited
in MAN

From the normal measurement display, press and hold
played on the main display.

If you have set the password (P.21 = ON) instead of SET the display shows PAS (password entry request). Set the
numeric password using

If the password is correct the unit will show OK U or OK A depending on the entered password is user or the ad-
vanced level. The password can be defined with parameters P.22 and P.23. Factory default is 001 and 002 respec-
tively.

If the entered password is wrong the unit will show ERR.

After having entered the password, the access is enabled until the unit is re-initialized or for 2 minutes without
pressing any key.

After having entered the password, repeat the procedure to access the parameter setting.

Press
display.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

Parameter setting (SETUP) from panel

and then press
to select the desired submenu (BAS ADV ALA ... ) that is shown on the alphanumeric
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
number
of steps
Connected
Manual step
for 3 seconds to recall the main menu. SET is dis-
to move to next digit.
Total
Model
steps
selection
enabled
44