Installation - ITALFARAD PFC144evo Manual De Uso


PFC144evo regulator is designed for flush-mount installation. With proper mounting, it guarantees IP54 front
protection.

Insert the device into the panel hole, making sure that the gasket is properly positioned between the panel and the
device front frame.

From inside the panel, for each four of the fixing clips, position the clip in its square hole on the housing side, then
move it backwards in order to position the hook.

Repeat the same operation for the four clips

Tighten the fixing screw with a maximum toeque of 0,5 Nm

In case it is necessary to dismount the system, repeat the steps in opposite order.

For the electrical connection see the wiring diagrams in the dedicated chapter and the requirements reported in
the technical characteristics table.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

Installation

ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
E
N
59