Publicidad
Idiomas disponibles
Idiomas disponibles
2_WARNING:
Always wear proper personal hearing protection that conforms
to
ANSI $12.6 (S3.19) during
use. Under some conditions and duration of use, noise
from this product may contribute to hearing boss.
SAFETY
GUiDELiNES
- DEFiNiTiONS
It is important for you to read and understand this manual.
The information it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this information.
Z_ DANGER:
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
z_ WARNING:
Indicates a.potentially hazardous situation which, if not avoided, could
result in death or serious tnjury.
Z_ CAUTION:
Indicates a.po.tentially hazardous situation which, if not avoided, may
result in minor or moderate tnjury.
C..AU.TION:
U.sed withou! the safety ale.rt symbol.ind.icates a potentially hazardous
situation wnicn, iTnot avoided, may result in property damage.
The label on your tool may include the following symbols.
V .......................... volts
Hz ........................ hertz
min ........................ minutes
- - - ...................... direct current
[] .......................... Class II Construction
z_ ........................ safety alert symbol
.../min .................... revolutions or
reciprocations
per minute
Extension
Cords
A .......................... amperes
W ........................ watts
,x, ...................... alternating
current
no ........................ no load speed
G ........................ earthing terminal
bpm ..................... beats per minute
When using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord wilt cause a drop in line voltage resulting in loss of
power and overheating. The following table shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
(0-7,6m)
(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
51-100
101-200
201-300
(0-15,2m) (15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere
Rating
More
Not more
American Wire Gauge
Than
Than
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Recommended
Publicidad
