Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Warnings
and instructions:
Drills
Z_WARNING: Shock hazard. When drilling or driving into walls, floors or wherever
live electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF
THE TOOL! Hold the tool only by the plastic handle(s) / housing to prevent shock.
• Do not lock the toot ON when drilling by hand. Refer to Operating Instructions-Switching
On and Off.
• Hold drill firmly with both hands to control the
twisting
action of the drill (figure A). If your drill is
equipped
with a side handle, always use the side
handle.
z_WARNING:
Drill may stall (if overloaded or
improperly used) causing a twist. Always expect the
stall. Grip the drill firmly to control the twisting action
and prevent loss of control which could cause
personal injury. If a stall does occur, release the
trigger immediately and determine the reason for the
stall before re-starting.
• Always unplug the drill when attaching or removing accessories. When attaching
accessories in the drill chuck, it is important to securely tighten the chuck using all three
holes to prevent slippage. When using a keytess chuck, hand tighten firmly.
Motor
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your drill will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz AC
or DC power. This information is printed on the nameplate. Lower voltage wilt cause loss
of power and can result in over-heating. All Black & Decker tools are factory-tested; if this
tool does not operate, check the power supply.
Assembly
Z_WARNING:
To reduce the risk of injury, before assembly, make sure that the tool is
switched off and unplugged.
Attaching
the side handle
and depth
stop -
(fig.
B}
Your drill is equipped with a side handle, it must be
installed properly to control the drill.
• Turn the grip counterclockwise
until you can slide the side
handle (5) onto the front of the toot as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop (8) into the mounting hole as shown.
• Tighten the side handle by turning the grip clockwise.
• Be sure side handle is secure and will not rotate about the
tool.
i i
Inserting
a drill bit or other accessory
(fig. C }
_WARNING:
Do not attempt to tighten drill bits (or any other accessory)
by gripping
the front part of the chuck and turning
the tool on. Damage to the chuck and
personal injury may occur when changing
accessories.
z_WARNING: Always ensure the bit is
secure before starting
the tool. A loose bit
may eject from tool causing possible
personal injury.
• Open the chuck by pressing the manual
spindle lock button (7) and turning the sleeve
(9) counter clockwise.
• Insert the bit shaft (10) into the chuck to about
3/4 in.(19 mm) depth, centered in the jaws.
• Firmly tighten the chuck by pressing the
manual spindle lock button (7) and turning
the sleeve (9) clockwise until it is tight.
Publicidad
