Acuity Brands LITHONIA LIGHTING TCU 350L Manual De Instrucciones página 2

INSTRUCTIONS FOR Lithonia Lighting TCU
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR
SIGNIFICANT PROPERTY DAMAGE.
maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations. If you donot understand
these instructions or additional information is required, contact LITHONIA LIGHTING or your local LITHONIA LIGHTING distributor.
WARNING: RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS
ENERGIZED.
WARNING:
DO NOT USE ABRASIVE MATERIALS OR SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE,
WHICH MAY RESULT IN PERSONAL INJURY.
WARNING
: RISK OF PERSONAL INJURY – This product may have sharp edges. Wear gloves to prevent cuts or abrasions when removing
from carton, handling, installing and maintaining this product.
WARNING:
RISK OF FIRE. Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacturer's warnings,
recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
IMPORTANT SAFEGUARDS:
including the following:
• Do not use outdoors. Suitable for use in damp location 32°F – 104°F (0°C – 40°C).
• Consult local building code for approved wiring and installation.
• Disconnect A.C. power before servicing and installation.
• Do not mount near gas or electric heater.
• Do not use this equipment for other than intended use.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• All servicing on this equipment should be performed by qualified personnel only.
• Equipment should be mounted in locations and at heights where it will not be subject to tampering by
unauthorized personnel.
• Use caution when servicing batteries.
• Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.
PAGE:1 of 5
LED Steel Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
For your protection, read and follow these warnings and instructions carefully before installing or
When using electrical equipment, basic safety precautions should always be followed,
SAVE THIS INSTRUCTIONS
and deliver to owner after installation