Eldom vess OB90 Manual Del Usuario página 11

INSTRUKCJA OBSŁUGI
ODKURZACZ BEZPRZEWODOWY OB90
• GENERAL DESCRIPTION
1. Upright-vacuum-cleaner handle
2. Upright-vacuum-cleaner ON/OFF
3. Power control
4. Arm lock button
5. Hand vac lock button
6. Hand hoover
7. Dust container lock
8. Dust container
9. HEPA filter
10. Socket for nozzles (23)
11. Upright-vacuum-cleaner body
12. Brush
13. Hand vac switch
14. Indicator light
15. Brush holder (12)
16. Brush lock button (12)
17. Brush roller lock button (19)
18. Brush roller lock (19)
19. Brush shaft
20. Charging base - upper part
21. Suction cup holder (23)
22. Charging base - lower part
23. Suction cups for handheld hoover
24. Power supply
• INTENDED USE
OB90 cordless vacuum cleaner is intended for vacuuming floors, but also curtains, upholstered furniture,
etc. Thanks to its universal design, it can easily remove dust both at home and in the car.
Use of the hoover is only possible after charging the internal battery.
• ASSEMBLY
− Unpack the appliance and check that no components are damaged.
− Assemble the charging base (20+22).
− Hold the handle (1) to lift the arm and lock it. To fold the arm, press the button (4).
− On the brush (12), push the lock button (17), remove the lock (18) and insert the shaft (19). Then insert
the locking device (18).
NOTE. Do not use the upright hoover without the roller (19) in the brush (12) correctly installed.
− Install the complete brush (12) in the socket (15). To remove the brush (12), press the button (16) and pull
out the brush (12).
− Insert the filter (9) into the container (8) and then assemble the whole into the handheld hoover (6).
NOTE. Do not use the upright and handheld hoover without the HEPA filter (9) and container (8)
in place.
− Place the assembled hand hoover (6) in the body (11). To disconnect the handheld hoover (6), press
the button (5) and pull it out.
− Connect the power supply end (24) to the socket on the charging base (20). Connect the power supply (24)
to the mains in accordance with the parameters specified in the instructions.
− Ensure that the assembled upright hoover is switched off and place it in the charging base (20). If the power
supply unit is connected to the socket on the base (20), charging will automatically start as indicated
by the indicator (14).
INSTRUCTION MANUAL
VACUUM CLEANER OB90
• TECHNICAL DATA
− Rated power: 135W
− Supply voltage: 100-240V~ 50/60Hz
− Operating voltage: 22.2V
− Charging voltage: 26.0V
− Volume: <80dB
− Operating times after full charge
 at high speed for up to 20 minutes,
 at low speed for up to 30 minutes.
− Dust-container capacity: 0.5l
− Battery: Li-ION 22.2V, 2200mAh
•
SPECIFICATIONS POWER SUPPLY
− Model: CZH013260050EUWH
− Eldom Sp. z o.o.,
ul. Pawła Chromika 5a, 40-238 Katowice
− Input voltage: 100-240V~
− Input AC frequency: 50/60Hz
− Output voltage: 26,0V DC
− Output current: 0,5A
− Output power: 13W
− Average active efficiency: >83,39%
− Efficiency at low load (10 %):
115V/84.33%; 230V/84.45%
− No-load power consumption: <0,10W
EN
11