EUROM DryBest 10 Manual Del Usuario página 25

Operation
WARNING
Before every use, make sure that:
• you operate the device with dry hands;
• the device is clean and dry;
• the device is not damaged;
• the device is not covered or blocked.
CAUTION
When the device is turned on, it will emit a sound. This is caused by the
compressor and fan starting up.
CAUTION
The compressor has a delay of at least 3 minutes between stopping and starting.
1. Press the POWER button.
2. The device is switched on.
3. The compressor (and power indicator for DryBest 20) will now light up continuously.
◦ The compressor indicator lights up continuously only when the humidity is higher than
the desired humidity. Otherwise, the compressor indicator flashes to indicate that the
compressor is not working.
4. The display will show the air humidity.
5. Press the POWER button again to switch off the device.
Set the air humidity
The optimal humidity level, both for your health and your belongings, lies between 45% and
65%.
1. Press the air humidity up or down button to set the desired air humidity.
◦ You can set the desired humidity between 30% and 90% (at 5% intervals).
2. The display flashes the set humidity for a few seconds.
3. The display will show the current air humidity.
Once the required air humidity level has been reached, the compressor will automatically be
switched off. The fan continues to operate. The dehumidifier keeps the air in the room moving
and is therefore able to detect humidity and switch it back on in time.
If the air humidity rises more than 3% above the set air humidity, the compressor is
automatically switched on.
If you set the humidity with the DOWN button to CO, the device works continuously.
Set the timer
When the device is not in operation (connected and in the off position), you can set the time at
which it should start.
25