When the device is in operation, you can set the time at which it should stop.
1. Press the TIMER button .
2. The timer indicator will light up.
3. The set hours set appear on the display.
4. Press the TIMER button to add an hour.
◦ Cancel the timer setting by setting the time to 0.
The timer setting is forgotten if you switch off the device manually, but remains in memory if the
device stops because the tank is full or because it is defrosting.
Change fan speed
This only applies to the DryBest 20.
1. Press the fan speed button to set the fan speed:
◦ 1 light: low fan speed.
◦ 2 lights: high fan speed.
Laundry drying function
This only applies to the DryBest 20.
1. Press the Laundry drying function button.
2. The Laundry drying function indicator will light up.
3. The device will continually dehumidify at a high fan speed to dry your laundry quickly.
Defrosting
If the evaporator freezes, the operation of the device is automatically interrupted and it starts to
defrost.
• DryBest 10: the defrost indicator lights up.
• DryBest 20: defrosts automatically (has no defrost indicator).
Drainage
WARNING
Do not remove the float from the reservoir. Without the float, the device is
unable to detect a full reservoir, which could lead to water leakage.
CAUTION
The appliance will not work if the water tank is not properly inserted. In that case
the 'water tank full' indicator light will remain on.
CAUTION
When the water tank is full, the compressor stops out of self-protection. A tone
sounds repeatedly to indicate that the reservoir needs to be emptied.
26