Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Figure 1
Handle
For work safety and convenience, please use the auxiliary handle. Auxiliary handle can be mounted on the
two side of the body. (Figure 1)
auxiliary handle. Auxiliary handle can be mounted on the
Grinding wheel cover
Align the convex point on the grinding wheel cover to the slot of front cover, and then rotate the cover to the
position as figure 3. (Figure 2)
to the slot of front cover, and then rotate the cover to the
Fasten the tightening screw (Figure 3)
upper plate
grinding wheel
lower plate
Figure 4
Disassembly or assembly of the grinding wheel
Pull off the power plug before the assembly, and the safe security linear velocity is not less than 80 m / s
Align the notches to assemble the lower plate on the output shaft, assemble the grinding wheel on the lower
plate and screw the upper plate to the output shaft. (Figure 4)
Press down the self-lock cap, and use the wrench to tighten the upper plate. (Figure 5)
Rotate 180°
Figure 2
loosen
wrench
tighten
Self-lock
cap
Figure 5
screwdriver
Self-lock cap
Figure 3
switch
Figure 6
Keep Working
5
Publicidad
