Publicidad
Idiomas disponibles
Idiomas disponibles
Switch operation
Important: be sure the self-locking button is loosened and the switch is in the off position before power on.
1. Start
Press and push the switch to push forward, and then press down the front of the push block to lock the switch.
2. Close
Press the switch to push the back of the block, switch to the back of the block, and the tool is turned off. (Figure 6)
Effective & safe grinding method
Important: it is prohibited to make the grinding operations without the
wheel protective cover, be sure to turn off the power and let the grinding
wheel stop completely before place the wheel.
1. Use the wheel with the right part, otherwise it will damage the wheel.
2. Operate with the force equal to 1/2 of power tool weight, which can get
the satisfactory results. The excessive force will be overload to damage
the motor and the grinding wheel.
3. Usually, the grinding part of the grinding wheel or disk is maintained in
the range of 15 ° -30 ° with the processed surface. (Figure 7)
4. Do not move toward the direction A when using a new wheel. Otherwise, it may cut off the workpiece. It is
possible to move in both directions A, B when the wheel side & corner get round. (Figure 7)
Maintenance and Inspection
Caution: be sure to turn the power off and unplug before maintenance and inspection.
1. Remove the dust, oil and the other bad attachments on the tool body usually, keep the tools clean.
2. Check the tightness of the connecting parts and screws. And the protective cover of the grinding wheel can
not be moved by hands.
3. Check the damage of the power cord insulation layer always.
Replacement of electrical brush
It is necessary to replace electrical brush when the tool has larger spark or does not turn. Use a screwdriver
to remove the electrical brush cover and remove the worn electrical brushes, assemble a new brush and use
the hand confirm free slide in the slot, then tighten brush cover tightly, be sure to replace two brushes
simultaneously with the "ELITE" original brush.
Quality assurance
Tools from "ELITE" factory have been guaranteed, and its repair or replacement period will be used to meet
the provisions of national laws or standards.
The factory warranty is not available for the damage of overload, natural depletion, or the incorrect operation.
It is prohibited to disassemble the tool, which can be repaired only if the tool has been returned to the
supplier entirely.
Figure 7
6
Keep Working
Publicidad
