Bras TURIA 12 Manual De Instrucciones página 12

EN GLIS H
TURIA
counterclockwise (see figure 2).
figure 2
5 Remove the bowl gasket.
6 Slide drip tray out and empty it.
5. 3. 2 CLEANING
ATTENTION
Before any disassembly and/or cleaning pro-
cedure make sure that the dispenser is discon-
nected from its power source by unplugging it
or switching off the 2-pole wall breaker.
IMPORTANT
Do not attempt to wash any machine compo-
nents in a dish washer.
1 Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-
140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions,
as too strong a solution can cause parts
damage, while too mild a solution will not
provide adequate cleaning.
2 Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in
the cleaning solution.
3 Rinse all cleaned parts with cool clean
water.
ATTENTION
When cleaning the machine, do not allow
excessive amounts of water around the electri-
cally operated components of the unit. Electri-
cal shock or damage to the machine may
result.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastics parts
5. 3. 3 SANITIZING
Sanitizing should be performed immediately prior
to starting the machine. Do not allow the unit to sit
for extended periods of time after sanitization.
1 Wash
hands
antibacterial soap.
2 Prepare at least two gallons of a warm
(45-60 °C 120-140 °F) sanitizing solution
(100 PPM available chlorine concentration
or 1 spoon of sodium hypoclorite diluted
with two litres of water) according to your
local Health Codes and manufacturer's
specifications.
3 Place the parts in the sanitizing solution
following manifacture 's specifications
(about five minutes).
4 Place the sanitized parts on a clean dry
surface to air dry.
5 Wipe clean all exterior surfaces of the
unit. Do not use abrasive cleaner.
5. 3. 4 ASSEMBLY
1 - Slide the drip tray into place.
2 Fit bowl gasket to the bowl around its
seat.
Place the bowl on the unit and then push it
down all the way. Fix the bowl by rotating
(2) it clockwise.
Wet the gasket for ease of insertion (see
figure 2).
3 Push (1) the dispensing button and
insert (2) the pinch tube into its seat in the
evaporator bottom.
L i g h t l y p u l l ( 3 ) t h e p i n c h t u b e e n d
downwards till it is well arranged (see figure
3).
4 Use fresh product to chase any
remaining sanitizer from the bowl(s). Drain
12
with a suitable
figure 3