Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS FOR STACKING ADDITIONAL UNIT
COMPONENT DESCRIPTION
(2) Guard Rail Panels
(4) Lock Pins
(4) 18" Outriggers
(8) Snap Pins
(4 From additional unit)
(8) 6" Casters
(4 From additional unit)
If the desired platform height is
between 6' and 11' 6" additional
unit is required.
WARNING:
STEP 1
Install caster (E) into outrigger (C) and secure with snap
pin (D). Repeat for remaining 3 outriggers. See Fig. A.
STEP 2
Install outriggers (C) by clamping to end frames
perpendicular to the side braces. Clamps must be
tight and casters must make contact with the floor. Set
caster brakes. See Fig. B
STEP 3
Install end frames of upper unit onto end frames of
base unit (See Fig. C). Insert 4 snap pins (D) to secure
scaffold units. Attach 2 side braces to upper end
frames at desired platform height. Place platform so
that it is fully seated and level in both side braces. Be
sure the deck pins are in the engaged position.
STEP 4
Install guard rail panel into side brace sockets and
secure with lock pin. (See Fig. D) Guard rail gate must
swing inward above platform. Repeat for other side.
WARNING:
The following instructions are for safe use and operation of the NSRS-72MP model's trap door. Be sure to inspect
trap door components before each use. Ensure proper closure of trap door from its own weight. Check that hinges
are in good condition.
Access the platfrom from inside of scaffolding through the trap door. Trap door must be closed when not in use.
Do not block trap door in open position. The trap door access must always remain free from debris or tools in
order to maintain safe operational use.
A
A
B
C
D
E
• When stacking second unit, outriggers and guardrails are required.
• Do not stack more than 2 units high.
• All scaffolds must be restrained from tipping.
• Guard rail gate must swing inward above platform.
• Make sure each scaffold level has both side braces installed.
• Follow all applicable ANSI & OSHA guidelines along with state and local codes for
the use of this product
• Casters used on scaffold and outriggers must be identical in size
SEE ILLUSTRATION
E
C
Fig. A
Snap
Pin
Fig. C
B
D
Tighten
End
Frame
Outrigger
Fig. B
Side
Brace
Socket
Fig. D
Publicidad
