Franke GALILEO SLIM A600 Manual De Uso página 11

Timer (generic) Timer with alarm for generic use.
To enable: switch on the hob making sure there are no pans or active cooking areas.
The 3 digits to control the timer show "- - -".
Press the digit to access the timer menu and display "0 0 0".
Press "+" or "-" to set the timer countdown.
To confirm the set time, do not touch anything for 10 seconds.
When the countdown has finished, the digits are reset and an audible signal is emitted. The func-
tion can be interrupted by pressing any key.
Repeat the steps described to change the countdown value.
To disable: switch on the hob making sure there are no pans or active cooking areas.
Press the digit to access the timer menu and use "+" and "-" to set the display to "0 0 0" "-" or press
the On/Off key.
Melting
To enable: select one of the 4 cooking zones and press
The digit of the selected zone shows
To disable: press
Heating function This function is used to heat a pan to the maximum power before continuing to cook at a selected
level. The time interval for which the cooking zone is held at maximum power depends on the final
cooking level that has been set. See the table:
Power level
1
2
3
4
5
6
7
8
9
P
To enable, with a pan on the hob and the cooking zone selected, press and hold the selected value
(from 1 to 8) on the power bar for 3 seconds. The display of the corresponding cooking zone indic-
ates "A".
The cooking level can be increased, but the function is disabled if it is decreased.
It can also be disabled by touching and holding down the key of the cooking zone in question for 3
seconds.
Pause function This function allows you to pause/restart any active function on the hob, by reducing the power
available in the cooking zone and resetting all the functions. If the Pause function is not disabled
with 10 minutes, the hob automatically switches off.
To enable: With a pan on the hob and the cooking zone selected, press and hold the Pause func-
tion key
To disable: press and hold
seconds. The function is disabled and the hob continues with the previous settings.
Recall function This function is used to recall the function settings of the hob if it is switched off by mistake or the
electricity is unexpectedly cut off.
When the hob is switched off, if it is switched on again with 6 seconds by touching
key flashes for 6 seconds. Press the
ted to confirm the operation.
or press .
for at least 1 second. All the displays show
for 1 second until it starts flashing. Press any other key within 10
Hours - Tenths - Minutes
.
.
Timer (seconds)
48
144
230
312
408
120
168
216
Not available
Not available
.
key to recall the functions set previously. A beep is emit-
, the
11