Descargar Imprimir esta página

Mx Onda MX-VC2644 Manual De Usuario E Instalacion página 56

Placa vitrocerámica para encastrar con tres zonas de cocción

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING THE CERAMIC HOB
Type of dirt
Daily soiling on the
glass surface
(fingerprints, marks,
food stains or
unsweetened spills)
Spills from
sugary foods
Dirt and spill stains
on the control panel
How to clean
1. Disconnect the power supply
from the board using the
switch or differential enabled
for this.
2. Use a ceramic hob cleaner
while the surface is warm (but
not hot!)
3. Rinse and dry the plate with a
clean cloth or paper towel.
4. Reconnect the board to power
Remove them immediately using
a spatula or scraper suitable for
glass-ceramic hobs, be careful
with hot surfaces in the cooking
zone:
1. Disconnect the power supply
from the board using the
switch or differential enabled
for this.
2. Hold the putty knife or scraper
at a 30 ° angle and scrape dirt
or spillage to a cool area of
the plate.
3. Wipe up dirt or spills with a
kitchen towel or paper towel.
1. Disconnect the power from the
board using the switch or
differential.
2. Clean the control panel area
with a clean, damp sponge or
cloth.
3. Completely dry the control
panel area
4. Reconnect
the
power.
When turning off the power to
the
indication of a hot surface, but
the cooking zone may still be
hot!
Use special scouring pads for
glass ceramic hobs. Do not use
harsh, corrosive or abrasive
cleaners that can damage the
plate. Always read the label to
see if your cleanser or scourer is
suitable. Never leave residue on
the surface, the glass can get
stained.
Remove stains from melting and
sugary foods or spills as soon as
possible. If allowed to cool on the
glass, it can be difficult to clean or
even permanently damage the
surface of the hob.
Cut Hazard - When the safety
cover is retracted, the blade on a
scraper becomes sharp. Use it with
great care and always store safely
and out of the reach of children.
Liquid spillage in the area of the
control
malfunction of the ceramic hob, the
touch
properly.
Be sure to thoroughly clean and
dry the control panel area before
board
to
reconnecting the board to power.
14
Important
hob,
there
will
panel
can
cause
buttons
may
not
be
no
a
work

Publicidad

loading