Publicidad
Idiomas disponibles
Idiomas disponibles
ER21
E2
E3
E6
E8
E4-E5-E7-E9-ER20-ER22-
ER31-ER36-ER42-ER47-
EA-EH
16. MAINTENANCE -
REPAIR AND
CONFORMITY
• Make sure that maintenance on elec-
trical components is only carried out
by the manufacturer or by the service
technicians.
• Make sure that damaged cables are
only replaced by the manufacturer or
by the service technicians.
When contacting the service depart-
ment, please provide the following in-
formation:
• Type of fault
• Device model (Art./Cod.)
• Serial number (S.N.)
This information can be found on the
identification plate. The identification
plate is affixed to the bottom of the
device.
Information on the product pursuant
to EU regulation no. 66/2014
Reference standards:
EN/IEC 60350-2
Hob switches off.
The internal temperature of elec-
tronic parts is too high.
Corresponding
Empty or unsuitable pan.
cooking
area
Pan or ceramic glass surface tem-
switches off.
perature too high.
Electronic component temperature
too high.
Corresponding
Unsuitable pan.
cooking
area
The pan is losing its magnetic prop-
switches off.
erties and may damage the induction
hob.
Hob does not switch
Power supply voltage and/or fre-
on.
quency is out of range.
Cooking areas are
Fan fault.
turned off.
Fan blocked by dust or fibres.
Disconnect the hob from the power supply.
Wait a few seconds, then reconnect the hob to the power supply.
If the problem persists, call the After Sales Service and specify the error code that appears on
the display.
Let the hob cool down.
Please check if the hob has suffi-
cient ventilation.
If the error persists, please contact
the After-Sales Service.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
Use a suitable pan.
The error is automatically cancelled
after 8 seconds and the cooking
area can be used again.
If any other errors occur, the pan
must be changed.
If the error persists, please contact
the After-Sales Service.
Check mains voltage and/or fre-
quency.
If necessary, contact the After-Sales
Service.
Clean and remove foreign bodies
from the fan.
If the error persists, please contact
the After-Sales Service.
EN/IEC 50564
This appliance has been designed,
manufactured and sold in compliance
with the EEC directives.
17. TECHNICAL DATA
Product identification
Type: 4300
Model: GALILEO SLIM F600
Please see the identification plate af-
fixed to the bottom of the product.
The manufacturer makes continual im-
provements
to
reason, the text and illustrations in these
instructions for use may change without
warning.
Further information on the technical
data is available on the website:
www.faberspa.com
products.
For
this
15
Publicidad
