SCALANT Scarlo 1000 Instrucciones De Montaje página 22

Scarlo 1000 Outside Staircase Assembly Instructions
5) Assembly
Step 3
Now assemble the feet (pos. 2) on the lowest step. Use the screw (pos. 5),
the washer (pos. 4) and the nuts (pos. 3).
The position of the feet must also be aligned here according to the
calculated step spacing using the slotted holes. After alignment, the screw
connection can also be tightened.
1
Step 4 (without platform)
The fully assembled staircase is now erected and positioned at the desired
installation location. Fine adjustment is done with a spirit level. The
staircase must then be fixed to the wall using appropriate screws and
dowels.
Step 4 (with platform)
The platform is first fastened to the wall. To do so, first connect the platform
(pos. 20) to the platform supports (pos. 21). Use the screw (pos. 22), the
washer (pos. 23) and the nuts (pos. 24). The platform is now attached to the
wall together with the platform supports using appropriate screws and
dowels.
Now connect the steps to the platform. To do this, set up the stairs and
position them on the platform. Now fix the staircase to the platform using
the screw (pos. 6), the washer (pos. 4) and the nuts (pos. 3).
Step 5
Finally, the feet are fixed (anchored) to the floor.
If you have chosen a staircase without railings, assembly is complete
here.
2
-22-