Publicidad
Idiomas disponibles
Idiomas disponibles
Scarlo 1000 Outside Staircase Assembly Instructions
5) Assembly
Step 8
Now set the handrail pipe (pos. 11) on the handrail holders and fasten them
temporarily with the supplied cable ties (pos. 16) (Fig. 1). Start from the
bottom. If necessary, connect the individual pipe segments using handrail
connectors (pos. 14) (Fig. 2).
1
Step 9
As soon as you have temporarily fixed all the railing rods to the handrail
pipe with the cable ties and the individual pipe segments are attached using
the handrail connectors, start aligning the individual railing rods.
Use a spirit level to align the railing rods vertically. Once these are aligned,
mark the holes with a pencil and pre-drill with a drill bit (Ø 4 mm). Then
remove the countersunk screws (pos. (18) and screw the handrail holder to
the handrail pipe (Fig. 1). The same procedure applies to the premium
equipment (Fig. 2).
1
2
2
-24-
Publicidad
