Wiha speedE PocketDrive Manual Del Usuario página 13

OVERVIEW
About these instructions
Original operating instructions
These instructions facilitate the safe and effective operation of the
„speedE® PocketDrive" e-screwdriver. Keep these instructions for future
reference! Read these instructions prior to commencing any work. A
prerequisite for safe operation is compliance with all safety instructions
and operational directives in this publication. Observe the local accident
prevention regulations and general safety requirements for the types of
application for which the speedE® PocketDrive is to be used.
These instructions are copyright protected.
Except for internal purposes, disseminating these instructions to
third parties, duplication of any kind, even of excerpts, as well as the
exploitation and/or disclosure of the contents is not permissible without
the written approval of Wiha Werkzeuge GmbH, subsequently referred
to as the „Manufacturer". Violations shall require compensation. The
Manufacturer reserves the right to assert additional claims.
© Wiha Werkzeuge GmbH
Symbols in these instructions
WARNING!
This combination of symbol and signal word indicates a
potentially dangerous situation that can lead to death or
serious injury if not avoided.
ENVIRONMENTAL CONSERVATION
This combination of symbol and signal word indicates risk to
the environment.
INFORMATION
This symbol emphasizes useful tips and recommendations
as well as information for efficient and trouble-free operation.
Delivery contents
• speedE® PocketDrive
• Cable USB Type-C
• Manual
• Soft Bag
• 30 x 1/4"-25mm Standard bits
• 1 x 1/4"-58mm Magnetic Bit Holder
Legend for the overview graphic
1 USB-C charge Port
2
Screwdriver Handle
3 Power switch
Two lights = power mode
One light = material
protection mode
Symbols on your speedE® PocketDrive
Read the instructions!
This symbol instructs the user to read the instructions included.
Proper use
The e-screwdriver speedE® PocketDrive is exclusively intended for
fastening and tightening screws or to remove the screws and loosen
them. It is intended for machine screws in pre-drilled or self-tap screw
in soft materials. The electric screw fastening support makes it easier to
fasten screws.
The LED lamp on the speedE® PocketDrive can be used as
a torch.
EN
4 6.35mm Bit chuck
30 x 1/4" 25 mm bits
5
6 LED light
7 Switch
10