Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER USE
Fastening and loosening screws
Use the speedE® PocketDrive at an
ambient temperature of -5 °C – 40 °C.
4
5
Care
Clean the speedE® PocketDrive regularly by wiping with a slightly
dampened cloth. Keep the grip surfaces dry, clean and free from
oil or grease. Verify regularly that the moving parts of the speedE®
PocketDrive function as intended and do not jam, and they are not
broken or damaged.
Storage, carrying and transporting
The contained li-ion batteries are subject to the requirements of the
Hazardous Goods Law. The user may transport the tool on the street
without further requirements.
You must observe special packaging and labelling requirements
if you are using a third party for shipping. Consult an expert in
hazardous goods for preparation of the item to be shipped.
This tool is equipped with a li-ion rechargeable battery. To obtain the
longest possible battery life, the following is recommended:
15
1. Place the speedE® PocketDrive on the screw head.
2. Push the power switch, to choose one of two torque levels:
One light = material
protection mode; the torque
is 1 Nm
3. Start the speedE® PocketDrive - fastening support by push the switch
Push the clockwise switch to fasten the screw.
Push the counterclockwise switch to loosen the screw.
•
Store the tool where the temperature at -10°C - 50°C and free of
moisture.
•
Store the tool in a 30–50% charged condition.
•
Every six months of storage, fully charge the tool and then use it.
•
Do not store the tool in an environment with temperature higher
than 50 °C.
•
To avoid serious personal injury, always unplug the charger before
cleaning or performing any maintenance. Never disassemble the
tool. Contact your service dealer/distributor or info.de@wiha.com
for all repairs.
•
To prevent accidental injury, make sure that you carry the product
safely stored.
•
The battery is not replaceable.
Two lights = power mode; the
torque is 5 Nm
EN
Publicidad
