Publicidad
Idiomas disponibles
Idiomas disponibles
4
Drill upper pilot holes on the
marks.
Make sure the location on the wall to drill
the holes are strong enough to support a
weight of at least four times that of the TV
or LCD Monitor.
Note
Pilot holes must be drilled to a depth of 75 mm,
using a 5.5 mm diameter drill bit.
5
Install
on the wall using
WM1
suitable screws (not supplied)
and washers (not supplied).
× 2
8 mm × 60 mm
Note
Use a level to check whether
Precaution
Do not over-tighten wooden screw 8 mm ×
60 mm. Improper tightening could reduce the
holding power of wooden screw 8 mm × 60 mm.
6
Drill lower pilot holes on the
marks. (Refer step 4 for the drill
instruction.)
× 2
ø 5.5 mm
75 mm
WM1
WM1
is level.
× 2
− 9 (EN) −
7
Fit the suitable screws and
washers to the holes.
Note
Use a level to check whether
8
Pull out the arm of the bracket
to the end.
9
Install
. (Wall-Mount Hole
WM5
Pattern: 400 × 400 mm only)
400
400
M4
WM5
WM1
× 2
WM1
is level.
EN
Publicidad
