Electrolux LNT6ME18S Manual De Instrucciones página 18

Problem
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
on the rear wall of the refrigerator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Fifth temperature indicator blinks.
First or second temperature indica‐
tor blinks.
18 ENGLISH
Possible cause
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Extra Freeze function is switch‐
ed on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
The Extra Freeze function is switch‐
ed on.
There is no cold air circulation in the
appliance.
Communication problem.
Temperature sensor problem.
Solution
Set a higher temperature. Refer to
"Control panel" chapter.
This is correct.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Attach the melting water outlet to
the evaporative tray.
Switch off Extra Freeze function
manually, or wait until the function
deactivates automatically to set the
temperature. Refer to "Extra Freeze
function" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Refer to "Extra Freeze function"
section.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.