Stihl MH 700.1 Manual De Instrucciones página 37

6 Assembling the Cultivator
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
6.3 Fitting and Removing the
Wheels
6.3.1 Attaching the Front Wheel
NOTICE
■ The front wheel is only used for transport and
must be removed again for working.
► Stop the engine.
► Slide front wheel (1) into frame (2) so the
bores align.
► Insert pin (3) through the bore.
► Push retaining pin (4) through the bore in
pin (3).
Pin (3) is secured and front wheel (1) is locked
in position.
6.3.2 Removing the Front Wheel
► Stop the engine.
► Detach retaining pin (4) and remove pin (3).
► Pull front wheel (1) out of frame (2).
► Push pin (3) through the bore in front
wheel (1) and secure using retaining pin (4).
Pin (3) and retaining pin (4) are secured.
► Store front wheel (1) safely.
0478-404-9804-C
6.4 Attaching the Blade Spur
Assembling the blade spur
► Screw nuts (1) onto bolts (2) and screw into
the bores in adapter (3).
► Fit blade spur (4) into adapter (3) from below
so the bore on adapter (3) aligns with the low‐
ermost bore on blade spur (4).
► Insert pin (5).
► Push retaining pin (6) through the bore in
pin (5).
The blade spur is secured.
Attaching the blade spur
► Insert the adapter with attached blade spur (7)
into mount (8) on the tiller.
► Insert pin (9).
► Push retaining pin (10) through the bore in
pin (9).
► Screw in screws (11) and tighten firmly.
The blade spur is secured.
English
37