Publicidad
Idiomas disponibles
Idiomas disponibles
LSK 37
Safety and operating
instructions
Safety instructions
Important information for safer die
grinding
This manual follows the EC Machines Directive
regarding operator's instructions and relevant parts
of standards from CEN TC 255 "Hand-held power
driven non-electric tools – Safety".
These instructions concern operation, handling of
machine, inserted tool and equipments as well as
maintenance.
Neglect to follow these long established recom-
mendations may cause serious hazards.
Make sure that the operator has fully understood
the following recommendations and has full access
to them.
pay strict attention to following measures the oper-
ator has to take in order to avoid risks of misuse or
accident.
Installation
Follow the instructions for air preparation given in
the written instructions supplied with the machine.
When lubrication is recommended – use recom-
mended lubricants only.
Check hose size and air pressure. The air pressure
at the tool inlet with the grinder running shall not
exceed the maximum operating pressure 7 bar -
700 kPa - 100 psig or lower if other specified.
Avoid the risk of whipping hose – regularly check
hose, hose fitting and clamp conditions.
Check that the exhaust air is directed away to
avoid blowing dust or air from the work piece onto
the operator or other persons. Arrange for barriers
if possible.
When necessary, use exhaust hose and arrange for
dust collection.
© Atlas Copco Industrial Technique AB - 9836 099301 01
Pneumatically driven power tools are not gen-
erally insulated for coming into contact with
electric power sources.
Explosive atmosphere must not be ignited –
to prevent injury and property loss from fire
use other non sparking process.
Correct use of die grinders
Follow the information concerning intended appli-
cations, mounted wheels / rotary burrs and acces-
sories to be used given in the written instructions
supplied with the machine.
Avoid misuse
• Do not manipulate speed of die grinder.
• Do not use insert tools with lower maximum
working speed than spindle speed.
• Do not use other cutters than specified by the
manufacturer (no cutting off wheels or router
bits).
The tool must not be modified for product lia-
bility and safety reasons.
Avoid accidents when using the
machine
Potential injuries:
Eye injuries due to sparks, chips or wheel frag-
ments – always wear approved eye protection to
prevent vision loss.
Cutting or severing.
Drawing in or trapping of loose hair and clothing.
Safety Information
3
Publicidad
