Publicidad
Idiomas disponibles
Idiomas disponibles
ACTIVATE THE TIMER BEFORE USE
Please active the valves when getting the timer for the first
time, or it's been a long time since your last time to use it.
5) After zone 4 finishing its first self-inspection, turn on the faucet
a little bit to start test with water.
6) During test of each valve, please check whether the water flow
out or shut off as expected.
If yes, the timer valves are activated successfully, please use
the timer with confidence.
If not, please repeat the step 1~6 for several times, or contact
us immediately for support.
7) After test, take out the batteries to avoid testing circly. Then
re-insert batteries to start normal operaion.
Note:
When testing, please keep away from the water timer outlet to
avoid being splashed and wet.
1) Pulling out the battery box and install 4*AA
batteries.
2) Keep the faucet closed and turn the dial to
"ON".
3) Press and hold "OK/Manual" button and at
the same time insert the batteries to enter
the self-inspection mode.
4) Release "OK/Manual" button 3 sec later
and four valves will be opened and closed
in turn to finish self-inspection, each valve
costs 5 sec.
-07-
Publicidad
