Descargar Imprimir esta página

cecotec FAST&FURIOUS 9040 ABSOLUTE Manual De Instrucciones página 41

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
of the support rod fixing frame. Follow the indications on the figure. The support rod will
click into place. Fig. 2.
-
Insert it int the direction shown by the arrow and check if it is in place by pulling it back
after clicking into place.
Support rod height adjustment
-
Release the support rod lock, adjust to the desired height, and then fasten the support
rod lock again. Fig. 3.
-
Once the height is adjusted, you may use a hanger to iron sheets, dresses or delicate
garments comfortably. (Only included in Fast&Furious 9050 X-Treme)
Note
Before use, check whether there is deposits in the water pump inlet tank of the machine body.
If there is any deposit, please remove it. If the steam hose outlet is blocked, clear it.
Filling up the water tank
-
Open the water tank by pulling upward from the handle and add water.
-
Then place the water tank in the main unit and cover the water tank handle. Fig. 4
-
It is recommended to use tap water at room temperature to use the appliance.
-
Do not use hot water, vinegar, starch, detergent, additives or other chemical products.
-
If water in your zone contains high amounts of scale, mix demineralised water or distilled
water with tap water.
Warning
Do not use distilled, descaled, or perfumed water only.
How to use the steam station
Note
-
Be careful of hot water from the steam outlet of the iron before use to prevent burns.
-
When using the appliance, pay attention to prevent the danger caused by steam spray.
Horizontal ironing
1.
Place the clothes horizontally on the ironing board.
2. Plug the appliance into a power supply. The device will beep and the lack of water and
descaling indicators will blink and turn off.
3. The operation light indicator will turn on and then enter standby mode. Press the main
switch, the operation light indicator will blink.
4. The device will start preheating, this process will take 110 seconds approximately. During
this process, no steam will be emitted.
5. Once the device is preheated, the operation light indicator will remain steady on.
FAST&FURIOUS 9040 ABSOLUTE / FAST&FURIOUS 9050 X-TREME
ENGLISH
41

Publicidad

loading

Este manual también es adecuado para:

Fast&furious 9050 x-treme0559505596