Publicidad
Idiomas disponibles
Idiomas disponibles
GB
4.3 HUMIDIFIER MAINTENANCE
Refill Water Tank Alert:
For the Humidifier to work a minimum level of water is required. When water level is lower than the minimum level, the
display will show REFILL WATER message blinking. There may be residual water in the Water Tank Housing. The
message will show anyway because of the minimum water level required.
•
Remove the Tank Housing from the product. [Fig. 18a]
Remove the Tank Assembly from the Tank Housing. [Fig. 18b]
•
•
Remove any residual water and fill the tank through the Water Tank Inlet with distilled water until it reaches the
MAX line indicated on the tank. [Fig. 18c]
•
Refit the Tank Assembly into the Tank Housing. [Fig. 18d]
•
Refit the Tank Housing into the Product. [Fig. 18e]
Clean Water Tank Alert:
Your H-Purifier will monitor the condition of your Humidifier tank. A CLEAN WATER TANK alert will blink after 72 hours
from the last activation of the humidifier function, if there is still water in the tank. It will appear on the left side of the display
indicating action is required to clean the water tank.
Remove the Tank Body Housing from the product. [Fig. 18f]
•
•
Seperate the Tank Housing, Water Tank and Water Tank Cover, remove any residual water, clean all 3 thoroughly
and dry completely with a soft dry cloth. [Fig. 18g,h,i]
•
Re-assemble the Water Tank components, refill until it reaches the MAX line with distilled water.
•
Make sure the product is swtched on before re-inserting the tank.
•
Refit the Tank Housing into the product. [Fig. 18e]
Fig. 18
5. STORAGE OF YOUR H-PURIFIER
1.
Switch off the H-Purifier and unplug the power cord.
2.
Clean all the internal and external surfaces of the H-Purifier, the external layer of the Filter, the Water Tank.
3.
Remove the bottle from the diffuser. Refit the original cap onto the bottle and store it to protect from direct light. Clean the surfaces of diffuser
unit and Diffuser Cover. Make sure there is no residual of H-Essence or H-Biotics on any surface of the H-Purifier.
4.
Ensure all components are dry.
5.
Remove the Air Inlet Cover [Fig. 19a], reel in the power cord by pulling on the cord [Fig. 19b], fit the cord into the Storage Hook and fit the
plug into the Transportation Location. [Fig. 19c,d] Refit the Air Inlet Cover [Fig. 19e]
6.
Store the H-Purifier in a cool dry place.
Fig. 19
12
Publicidad
