FX -HV Operación Y Mantenimiento página 22

6. Lift the system slowly a few centi-
meters and check on Device if the load
is securely held. Always keep enough
distance and make sure that the Ex-
tension Arm does not swivel abruptly
about 90°. Make sure that the hoist
moves in the pivot axis through the
respective center of gravity
8. Put the load on a suitable under-
ground, swing the load slowly in the
horizontal position and make sure
that the hoist moves in the pivot axis
through the respective center of
gravity.
Turn OFF the magnet when the load is
secured on a stable underground.
22
7. Proceed further to the Vertical, make
sure that the load can not slip, e.g.
over the edge of a pallet or a table
edge.
Then lift the load completely in the
balance, make sure that the load is not
swinging and then transport the Load
9. Change your hoist from the Vertical
eyelet to the Horizontal eyelet and
remove your HV System from the
Workpiece