Special Notes - Genius SHUTTER Serie Manual De Instrucciones

the data on the rating plate match those of the
electrical distribution line. The installation must be
carried out in compliance with current regulations,
according to the manufacturer's instructions and by
qualified personnel. Installation regulations may vary
from country to country (*). Incorrect installation can
cause damage to persons, animals and things for
which the manufacturer cannot be held responsible.
The electrical safety of this equipment is achieved only
when it is correctly connected to an earthing system,
made as specified by current safety regulations. This
essential safety requirement must be verified and,
in case of doubt, ask for an accurate check of the
system by professionally qualified personnel. The
manufacturer cannot be held responsible for any
damage caused by the non earthing of the system.
Verify if the electrical capacity of the system is
adequate for the maximum power of the equipment
as indicated on the data-plate. In case of doubt,
contact a professionally qualified person. In particular,
this person must also make sure that the diameter of
the system's cables is suitable for the equipment's
absorbed power. We do not recommend the use
of adaptors and/or extension leads. If they must be
used, utilise only simple or multiple adaptor plugs and
extensions conforming to current legal regulations,
however taking care not to exceed the capacity
limits expressed in current value, marked on the simple
adaptor and on the extensions, and on the maximum
power marked on the multiple adaptor.
4. This equipment must be used only for the purpose for
which it was expressly designed. All other uses must
be considered improper and therefore dangerous.
The manufacturer cannot be held responsible for
any damage caused by improper, wrong and
unreasonable uses.
5. The use of any electric equipment entails the
o b s e r v a n c e o f s o m e f u n d a m e n t a l r u l e s .
In particular:
do not touch the equipment with wet or damp
•
hands or feet.
• do not use the equipment if you are barefoot
do not use extensions in shower rooms
•
• do not pull the power cable to disconnect the
equipment from the power supply line
do not leave the equipment exposed to atmospheric
•
agents (rain, sun, etc..) unless this is expressly
intended
• do not allow the equipment to be used by children
or incapable persons
6. Before performing any cleaning or maintenance
operation, cut the unit from the electrical mains,
removing the socket and switching off the system.
7. In the event of a fault and/or poor operation of
the equipment or system, switch it off, without
attempting to repair by direct intervention. Strictly
contact professionally qualified personnel.Any repair
of the products must be carried out solely by the
manufacturer or by an
centre, using exclusively original spare parts. Failure
to respect the above may compromise the safety of
the equipment.
When installing, use a single pole switch, as specified
8.
in the current safety regulations, with an opening
distance equal to and/or greater than 3 mm.
9. To avoid dangerous overheating, unwind the power
cable to its whole length.
10. Do not obstruct the aspiration or dissipation grills
11. The user of this equipment must not replace the
power cable If the cable is damaged, switch off the
equipment and call in strictly a professionally qualified
person to replace the cable.
If you decide to no longer use an equipment of
12.
this type, put it out of service by cutting its power
cable, after unplugging the cable from the power
supply line.
13. The equipment must be installed inside the boxes
to avoid danger due to electrical contact and by
moving parts.

SPECIAL NOTES

• Do not work close to hinges or moving mechanical units
which could cause dangerous situations through their
ease in gripping parts of the body or clothes, and due to
the difficulty in freeing oneself from their grip. Remember
that this equipment can supply very high forces which
can be the source of danger.
Do not enter the action range of the gate, door, shutter,
•
etc, while they are moving. Wait for them to stop
completely. A moving gate, door, shutter etc.. can be
dangerous to those entering their range of action.
• Activate the gate, door, shutter, etc..only when they are
completely visible and free of any impediments.
Do not allow children or animals to play, or stay near the
•
action range of the gate, door, shutter etc.
• Do not allow children to play with the opening
commands or with the radio control.
• Do not oppose the movement of the gate, door, shutter,
etc..because they can cause dangerous situations.
• Indicate on the gate, door, shutter, etc..that it is
automatic and remote controlled (if equipped with this
device) While operating, the electric motor creates heat
and therefore you must not touch the outer housing or
the oil it contains, until they have cooled.
• Inform all users of the gate, door, shutter etc..about these
warnings, if possible placing them in an appropriate
place.
• To guarantee an efficient system and make it operate
correctly, you must observe the manufacturer 's
instructions, arranging for professionally qualified
personnel to carry out routine maintenance of the
system. In particular we advise you to arrange for this
personnel to periodically control all the safety devices.
Learn to use the emergency manual control system as
•
specified in the instructions handbook
authorised service
7