Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
a)
Use this unit in the manner intended by AIRXCEL, INC. If you have questions, contact the
manufacturer.
b)
Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel
CAUTION!
FOR GENERAL VENTILATION USE ONLY. DO NOT USE TO EXHAUST
HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be done by qualified persons(s) in accordance with
all applicable codes and standards, including fire-rated construction.
STEP 1
The MAXXFAN Dome fan requires a minimum 6
1/4 inch diameter opening. If you are replacing
another type already installed, remove the old
existing vent. Remove all old sealant for a
minimum of 2" entirely around the opening.
STEP 2
Prior to installing the MAXXFAN Dome in the
opening, apply a continuous strip of BUTYL tape
or equivalent to the underside of the flange in the
groove provided.
CAUTION! When installing your MAXXFAN
Dome fan, only use a caulking/sealant
compatible with the flange (plastic product)
and the roof surface. DO NOT use materials
containing solvents such as or similar to
Xylene, Toluene, Methyl Ethyl Ketone (MEK),
Acetate or Acetone as they can damage the
flange.
Also,
Polysulfide
sealants must be avoided.
If in doubt, please contact the manufacturer of
your RV.
STEP 3 (Roof Installation)
When inserting the MAXXFAN Dome fan into
the roof opening:
• orient the fan with the button toward the
front of the coach.
• ensure that the fan wires are hanging to the
inside of the coach.
Center the fan in the opening.
Using the eight (8) screws provided, attach the
flange to the roof at each dimple location along
the flange.
Note: Opening the fan lid gives better access to
the flange for assembling the screws.
Screw into the dimple to pierce the flange, making
sure not to overtighten the screws to avoid
cracking the flange.
INSTALLATION INSTRUCTIONS
(Thiokol)
type
.
Publicidad
