Descargar Imprimir esta página

Airxcel MAXXAIR MAXXFAN DOME 3810i Instrucciones De Instalación Y Funcionamiento página 5

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

excess wire should lay in the garnish ring to keep
them contained.
Secure the garnish ring to the ceiling/wall with the
four (4) screws provided in the small parts package.
Reconnect the main vehicle power to the MAXXFAN
Dome.
This completes the installation of the
MAXXFAN Dome exhaust fan.
STEP 7 LED MAXXFAN Dome
Using the supplied wire nuts, connect the Positive (+) 12VDC supply wire to the MAXXFAN Dome
fan wire and the LED light wire marked "POS 12VDC" and the Negative (-) 12VDC supply wire to the
MAXXFAN Dome fan wire and the LED light wire marked "Neg. 12VDC".
If the sleeve is needed, insert the sleeve into the garnish ring positioning the notch in the sleeve
to line up the wiring.
Raise the garnish ring to the ceiling/wall ensuring that the garnish ring is centered over the fan
opening.
If using the sleeve, the sleeve will overlap the base that extends in the opening. This will help
center the garnish ring in the opening.
Ensure that the wires are not pinched. The wires should be routed on the outside of the sleeve.
The excess wire and wire nuts should lay in the garnish ring to keep them contained.
Secure the garnish ring to the ceiling/wall with the four (4) screws provided in the small parts
package.
Reconnect the main vehicle power to the MAXXFAN Dome.
This completes the installation of the MAXXFAN Dome fan.

Publicidad

loading