Uline H-11417 Manual Del Usuario página 2

• A driver's first responsibility is the safe operation of
the vehicle. Avoid distractions and pay attention to
the road to prevent a crash. Wait until it is safe to
operate mobile communication equipment such
as cell phones, text messaging devices, pagers or
two-way radios.
1. Secure forklift pocket onto broom hood using large
washers, large hex cap screws and 9/16" wrench.
(See Figure 1)
Figure 1
Forklift Pocket
Broom Hood
2. Thread knob through forklift pocket approximately 1''.
Position swivel foot so screw can engage locking ring
inside the swivel foot. (See Figure 2)
Figure 2
Swivel Foot
3. Tighten knob to lock both pieces together. Repeat
steps 1-3 for opposite side.
PAGE 2 OF 12
SAFETY CONTINUED
ASSEMBLY
Knob
• Airborne noise emission during use is below 70 dB(A)
for the broom operator.
• Operating broom vibration does not exceed
2.5 m/s to the hand-arm or 0.5 m/s
2
whole body.
4. Install one end cap on broom using small washers,
small hex cap screws and 1/2" wrench. (See Figure 3)
Figure 3
5. Insert bristles into broom hood and slide in until it
makes contact with the end cap. (See Figure 4)
6. Repeat step 4 for opposite end cap.
to the
2
End Cap
Figure 4
Bristle
0224 IH-11417