Publicidad
Idiomas disponibles
Idiomas disponibles
If there are devices for connecting dust extraction and collection facilities, please ensure
that they are attached and used correctly. Using such devices can reduce dust-related
hazards.
5.4
Power tool use and care
Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
Do not use the power tool if the switch cannot turn it on and off. A power tool with a broken
switch is dangerous and must be repaired.
Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
Maintain power tools. Check for misalignment or jammed moving parts, breakages or any
other feature that might affect the operation of the power tool. If it is damaged, the power
tool must be repaired. Many accidents are caused by using poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5
Service
Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 MACHINE-SPECIFIC SAFETY WARNINGS
Hold tool by insulated gripping surfaces when performing an operation where the cutting
tool may contact hidden wiring or its own cord. Contact with a "live" should shock the
operator. If cutting into existing walls or other blind areas where electrical wiring may exist
is unavoidable, disconnect all fuses or circuit breakers feeding this worksite.
Always make sure the work surface is free from nails and other foreign objects. Cutting
into a nail can cause the bit and the tool to jump and damage the bit.
Never hold the workpiece in one hand and the tool in the other hand when in use. Never
place hands near or below cutting surface. Clamping the material and guiding the tool with
both hands is safer.
Never lay workpiece on top of hard surfaces, like concrete, stone, ect... protruding cutting
bit may cause tool to jump.
Always wear safety goggles and dust mask. Use only in well ventilated area. Using
personal safety devices and working in safe environment reduces risk of injury.
After changing the bit or making any adjustments, make sure the collet nut and any other
adjustment devices are securely tightened. Loose adjustment device can unexpectedly
shift, causing loss of control; loss-rotating components will be violently thrown.
Never start the tool when the bit is engaged in the material. The bit cutting edge may grab
the material causing loss of control of the cutter.
Always hold the tool with two hands during start-up. The reaction torque of the motor can
cause the tool to twist.
Copyright © 2021 VARO
POWX0910
P a g e
| 5
EN
www.varo.com
Publicidad
