Publicidad
Idiomas disponibles
Idiomas disponibles
7.2
Depth adjustment (Fig. 2)
Locate the depth stop (4) on the left-hand side of the cutting machine. This continuously
adjustable stop is intended to limit the depth of the cut. Loosen it by turning it in anticlockwise
direction. To move the depth stop up or down to the desired depth according to the marker of
the scale label (3).
NOTE: Make sure the locking knob (10) is fixed firmly when operating this
machine.
7.3
Locking lever (13) for cutting machine body
When viewed from the front, the locking lever is located at the rear on the left-hand side. The
cutting machine body is spring-tensioned. Take care when releasing the locking lever. Grasp
both handles and brace yourself before releasing the lever. Press downwards to allow the
cutting machine body to move down. When you reduce the downward pressure, the springs
force the cutting machine body back up into its highest position.
The released position (a) or lock position (b) of locking lever as shown in Fig. 3.
CAUTION: The housing of the machine is under spring tension. When you
release the locking lever, it returns to its highest position.
7.4
Mounting and adjusting the parallel guide (Fig. 4)
The parallel guide can be used for cutting parallel to the edge of the work-piece.
Fit the guide rods (a) to the frame using the screws (b).
Release the two lock knobs securing the parallel guide and push them in so that the guide
is at the desired distance from the cutter head.
Tighten the two lock knobs.
Press the guide securely against the edge of the work-piece and execute the cut.
CAUTION: Abnormal vibrations may be due to a blunt cutter head.
7.5
Fitting the centre point (Fig. 5)
The centre point is used for routing circles.
Remove a guide rod (a) from the parallel guide.
Mount the centre point (b) to the guide rod.
Slide the guide rod in the router base plate and tighten the lock knobs.
Position the tip of centre point at the centre of your circle.
Press it slightly so that the tip is firmly in the wood. You can now cut the circle.
7.6
Dust extraction outlet (Fig. 6)
It is advised to use the dust extraction outlet. You can purchase a suitable
commercial vacuum cleaner or extract the dust via an extractor tube while
the cutting machine is in operation. The outlet must project out of the rear
of the machine. Two bolts and nuts are supplied to attach it.
Hold the dust extraction outlet (14) in position and lay the cutting machine on its side.
Push the screw through the hole of the template guide (a), dust extraction outlet (14) and
router's base plate (8) and until it projects at the fastening point for the dust extraction
outlet.
Tighten the screw with a suitable screwdriver and moderate force until the outlet is
securely attached.
Copyright © 2021 VARO
POWX0910
P a g e
| 7
EN
www.varo.com
Publicidad
