BEARWARE 305273 Manual Del Usuario página 20

6. Press the "UP" or "DOWN" buttons to select the alarm mode ( "rd" =
Radio, "bu = Summer; if "rd "or "bu" is selected, the corresponding alarm
is switched on).
If you need a second alarm, repeat step 2-6 (the second clock is shown as
"ALARM 2" (19) on the screen).
8. Activating the alarm
1. When an alarm is set, the "ALARM 1" (18) or "ALARM 2" (19) icon is shown
at the bottom of the display. If alarm 1 or 2 goes off, the corresponding icon
starts flashing. Press "SNOOZE / DIMMER" once to snooze the alarm and
will go off again after the configured snooze time.
2. Press any button other than "SNOOZE/DIMMER" to stop the alarm. The
alarm will go off on the next day. The corresponding icon does not disap-
pear.
3. If your second alarm is activated while the first alarm is going off or is in
snooze mode, then the second alarm disables the first alarm (the first
alarm is reset to go off again on the next day). The alarm volume automati-
cally increases gradually up to the maximum volume.
4. If you select the radio as an alarm tone, the station and the radio volume
will be the same as that selected the last time. The alarm volume increases
gradually up to the last set radio volume
5. The radio alarm plays until you stop it by pressing the "RADIO / SLEEP"
button.
9. Snooze function
As soon as the alarm goes off, press the "SNOOZE/DIMMER" button to defer the
alarm to a later time. The alarm sound or radio alarm then does off again later.
The duration of the snooze function is set using the time setting. The value can be
selected between 5 and 60 minutes.
20
English